Labpro measures
with a resolution of 12 bits
Menu in Datalyse
LabPro is connected to the pc with a serial cable that is included. The baud rate 38400.
You can measure on the
probes that comes with the logger: voltage, temperature, light irradiance and on
the Range sensor. LabPro has auto detection for new Vernier-probes. Old
Vernier-probes are connected using a converter cable from DIN to CBL. LabPro
will automatically calculate the correct value from the voltage of the probe.
When measuring normally the minimum time is 0.02 seconds and max number of measurements is 3000.
When scanning the minimum time is 0,00010 s and max number of measurements is 3000.
The LabPro has a number of advanced functions for calculation of data before sending them to the pc. These include:
Read Scan (Online)
In this menu point a scan is transferred to the table and the graph in Datalyse. LabPro beeps ready when the scan is complete. You can check the status of the scan in the memo and interrupt it if necessary.
Read List (Offline)
LabPro can be set to measure offline. In Datalyse this is done by selecting measuring and choosing the trigger setting »Manual«. Then you start measuring in the field by pressing the Start/Stop-button on the LabPro. Unfortunately the LabPro does not save sufficient information to tell if e.g. d/dt or d˛/dt˛ has been measured.
There it is recommended to select »Read List«, having one list read and written to the table in Datalyse. Then select Read List again until every list has been read, which is when the list read last is identical to the first.
When measuring offline it is recommended to log time as well. Otherwise you will not be able to draw the data points as a function of time!
Read Setup, example:
More information about cbl, cbl2 and labpro